Matrix PCB is not detected by jungleflasher and xbox

[canyou]

I have new matrix PCB during writing firmware i forgot to do outro/ATA so now it is not detected by jungle flasher but it is detected by matrix usb programmer
i tried to do what is recommended in jungleflasher instruction page 204 ,which says :using probe iii on the point MPX01

I could not located this point but i located this point in original Liteon pcb

Can you please advice me to resolve his issue

This post was deleted by steveo1978 on Wed Mar 13, 2013 5:55 am.
Reason: cause I am done with this site