Tortuga Cove - Your Source For Gaming and Hacking News

User Rating:  / 0

Category: X360

Published Date

Hits: 1717

Share this post

x360Pro V4 [forth generation]

Main Features:
NextGen Dual NAND Device
Easy Switch Between Stock Onboard NAND and Custom NAND by Extenal switch
No need to cut any tracks on the Xbox360 motherboard
Easy QSB Solution (Quick Solder Board)

Easy Wire Install Option Also Available(only 3 wires for slim/5 wires for phat)
Both Phat and Slim Versions
Compatible with any xbox360 with 16 MB NAND
Original Brand NAND to Match Stock For Security & Compatibility
Built-In USB, support MCU update no open your xbox and no others hardware
NAND Read/Write Hardware, quickly dump nand (Other SPI Hardware Not Required)
Compatible with Nandpro 2.0 and 3.0 software
Boot time almost in 5~30 seconds

Installation time - Around 30 mins after the console is completely stripped to the motherboard..

Installed

Switch location

Following their installation diagrams and user manual installation is pretty straight foward hook up all the nessecary points read/write both nands and your cookin
The fittment of the x360pro v4 is very good and every quicksolder point is very close to the actual point it needs to be soldered to..

The x360pro v4 is an all in one chip.. nand read/write functions - Glitch functions - dual nand functions..
the glitch portions debug light is on the switch and lights up blue to show the chip is functioning when a reset cycle is made.

Nand reading/writing is PIC controller based In my installation nandpro 2 was used..

The chip needs no programming what so ever by installer (you) only the nands need reading/writing , connect all your dots and add 3 wires in place..
Wires that need to be hooked up
R/B - Ready Busy signal for nands
post_out1
cpu rst [adjust length as needed to improve timing]

Install Diagram : http://www.x360pro.com/install_v4.asp
User Manual : http://www.x360pro.com/download/X360pro ... Manual.pdf

Overall this is a very well made chip, the nand read/write is a bit slower then some installers might be use to but the added benefit of not needing a programmer is excellent ! all you need is a mini-usb cable to connect the external switch to your PC to read/write and nandpro 2/3

The quality of the chip is very good, everything is nearly in place and fully soldered.. [ IE no loose caps/resistors ect ]

I would definately install this device again for consumers who request it.
As I have seen it is an affordable option out there.
Retails for around $30 USD..

Retailers can be located on their website http://www.x360pro.com

Questions ? post em up

Comments http://www.tortuga-cove.com/forums/viewtopic.php?t=3285&p=7229#p7229